Eames Plastic Armchair RE DAX, White, Without upholstery, Without upholstery, Standard version - 43 cm, Coated white

DAX means Dining Height Armchair X-Base,

The designation RE means that the Eames Plastic Armchair RE DAX is made from recycled plastic, a material from which the Eames Plastic Chairs RE have been produced since the beginning of 2024. With the introduction of the new sustainable material, three new colour nuances were also introduced, the new white “Cotton White”, the new yellow “Citron” and the new green “Emerald”, which replace the previous colours white, sunlight and green respectively.

The colours white, yellow and green differ from the original colours in the new recycled Eames Plastic Chairs version.

No, manufacture of the Eames Plastic Chairs in the unrecycled material version will cease in early 2024 and in the future only the sustainable material will be employed in the Eames Plastic Armchair RE DAX.

The Vitra Eames DAX meets the "GS" test standards and is tested up to 110kg. The way in which the chair is used is also important. Swinging, for example, causes a higher strain which can reduce the chairs lifetime.

Since Charles and Ray Eames designed the chairs the average height of the population has grown by around 10 cm. Therefore, in addition to adjusting the height of the Eames Lounge Chair in 2015, Vitra also adapted the Plastic Chairs (DSW/DAW, DSR/DAR, DSX/DAX) to better meet current user needs. The bases of the chairs are consequently now on average 2 cm higher. The change is minimal and accordingly can only be seen in direct comparison.

Only the Vitra Eames DSR with the powder coated base can be used outdoors; special additives in the polypropylene slowing down the fading process. Despite that Vitra recommend not to leave the chairs in the sun for longer than necessary. Felt pads are not suitable for outdoor use, for outdoor use the plastic glides should always be used. Upholstered versions are not suitable for outdoor use.

The seat height is determined according to the European standard EN 1335-1. This states that the chair be clamped in a special tester and loaded with a weight. The dimensions are then determined in the loaded state. The seat height being measured at a position defined by the standard and when in the load bearing state. The stated seat height cannot be measured with a conventional measuring device, rather is a normalised comparison value so that different chairs (for example, with and without height adjustment, or with varying thickness of seat cushion, etc.) can be compared with one another.

On the underside of the seat shell, the material marking PP indicates the polypropylene used for the shell, a seal certifies the safety of the chair and a sticker indicates the place of manufacture and serial number. In addition, Vitra always supplies the original fully assembled.

The new colour palette allows for more possible combinations and offers a broader spectrum of different colour shades with the delineation into "Natural Tones", "Mid Tones" and "Bright Tones".